Advertisement
Quick Links
Instructions for Installation and Care of Polaris General Soft Door Kit
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done
when the temperature is 70 degrees F. or warmer. This is to allow the Velcro to stick to the roll cage better, if you must
install outside in the cold it will help to warm the Velcro inside at room temperature until ready to install.
1. Carefully open the carton and remove the rolled-up Cab Enclosure on a large flat surface that is clean and free of
dirt or other material that may soil or scratch the windows of the Cab. Check over the parts included in the carton
with the parts list shown below:
2" Adhesive Velcro Strip
Door Panels
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2. Begin by cleaning the roll cage and plastic that surrounds the doors. Using rubbing alcohol is preferable. This step
is very important for the Velcro strips to properly adhere.
3. Now start installation by placing the 2" adhesive Velcro strips around the outside edges of the upper door frame.
Starting at the front of the frame first place the 18" strip as shown in the photo below.
2515 Bypass Road Flemingsburg, KY 41041
"
"
"
"
606-845-7439
PO-GENERAL-SDK01
20" long
4 each
18" long
2 each
12" long
6 each
4 each
10" long
2 each
Advertisement
Related Manuals for FALCON RIDGE Polaris General
Summary of Contents for FALCON RIDGE Polaris General
- Page 1 2515 Bypass Road Flemingsburg, KY 41041 606-845-7439 Instructions for Installation and Care of Polaris General Soft Door Kit PO-GENERAL-SDK01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when the temperature is 70 degrees F.
- Page 2 4. Next place the 20" strip as shown on the next page. 5. Next place another 12" strip in the rear corner as shown below. 6. Next place the 20" strip down the back of the cage as shown in the photo below.
- Page 3 7. Now move to the top of the door. Starting at the front place the 12" along the top of the door on the outside. Then follow the different angles of the door and place two 10" strips then a 12" strip. As shown on the next page. 8.
- Page 4 Cab to either extreme hot or cold temperatures when storing. 3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
-
Page 5: Return Policy
Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.