Table of Contents
Advertisement
Installation instructions
3. Manual
3.1 Use and storage of the manual
This instruction manual is intended for the machine user, owner
and technical installer and must always be available for
consultation.
The instruction manual indicates the intended use of the machine,
its technical features and provides indications as to its correct
use, cleaning and adjustments.
It also provides important indications for maintenance, for
residual risks and to carry out operations carefully.
This manual must be considered as a part of the machine
and must be KEPT FOR FUTURE REFERENCE until the final
scrapping of the machine.
The instruction manual must always be available for consultation
and preserved in a dry and protected area.
Should it be lost or damaged, the user can request a new manual
from the manufacturer or retailer, indicating the model and serial
number of the machine shown on its rating plate.
This manual reflects the state of technology at the time it was
drafted. The manufacturer reserves the right to update production
and following manuals without being obliged to update previous
versions.
The manufacturer will not be held liable in cases of:
• improper use or misuse of the machine
• use nonconforming to that expressly specified in
this publication
• serious shortcomings in intended and recommended
maintenance
• changes to the machine or any unauthorised
intervention
• use of non-original spare parts or not specific for
the model
• total or partial failure to comply with the instructions
• exceptional events
3.2 Scope
BEFORE INSTALLING THE APPLIANCE READ THIS
MANUAL CAREFULLY
Residential ventilation appliances convey outdoor air
through the cross-flow heat exchanger and distribute it to
the different rooms by means of a duct distribution system.
Moist and stale air is suctioned and then, again passing
through the cross-flow heat exchanger, is exhausted to the
outside of the appliance by residential ventilation.
4
Lindab reserves the right to make changes without prior notice
2022-01-28
li n d a b | w e s i m p l i fy c o n s t r u c t ion
3.3 Machine identification
There is an identification label on each appliance bearing
the data of the manufacturer and the machine type (See
Figure "1").
Fig.1.
ENERGY- S
RHR - ---
SIZE
TYPE
MAXIMUM
MAXIMUN
POWER INPUT
CURRENT INPUT
- - - W
- - - A
4. End of use
4.1 Waste disposal
Consumables and replaced parts should be
disposed of safely and in accordance with
the environmental protection legislation.
RHR-CF
IP21
230V
50Hz
QUALITY
07/03
CONTROL
2017
021B001
Advertisement
Table of Contents
