Table of Contents
Advertisement
Installation instructions
11.2 T-EP touch controller
This device was designed for the control of controlled
mechanical ventilation units. It is suitable for ENERGY
SMART units.
The Main Screen on the control panel permits access to
two settings sub-menus:
1. USER Settings Menu where the user can select the
operating mode and set the clock;
2. TECHNICAL Settings Menu where the installer can
calibrate the flow rate, change the standard unit op-
erating parameters and monitor the operating state.
On the main screen, the user can view alarm reports and
main readings of the temperature and humidity.
The USER Settings Menu offers these options:
1. Manual selection of the following preset ventilation
modes:
a) Party Mode - Intensive timed ventilation
b) Holiday Mode - Permanent or timed anti-mould
ventilation.
2. Automatic Mode - Available for units equipped with
air quality sensor (humidity or CO2).
3. Customised selection of desired air flow rate in
manual mode:
a) 100% - Nominal ventilation (standard)
b) 70% - Reduced ventilation (nighttime)
c) 45% - Humidity Control for High Humidity Rate
Environments
d) 25% - Humidity Control for Low Humidity Rate
Environments
4. Weekly Programming.
22
Fig. 16
The TECHNICAL Menu offers these options:
4
and another 4 weekly programs can be set up according to
the user's specific requirements.
The User Settings menu allows the user to enable or disable
the Weekly Program configured by the installer.
Lindab reserves the right to make changes without prior notice
2022-01-28
li n d a b | w e s i m p l i fy c o n s t r u c t ion
The MAIN SCREEN features the following options:
1. The preheating icon indicates activation of Anti-
freeze mode.
2. A timed warning icon lights up to suggest filter
replacement.
3. A damper bypass icon indicates automatic activa-tion
of free-cooling mode.
4. Weekly Program Display 4 .
DAY
1. Option of confirming or editing the operating pa-
rameters.
2. Monitoring of work conditions.
3. Setting the nominal calibration speed of the fans.
4. Input and Selection of the Weekly Program available to
the user.
The four Weekly Programs can be set by the installer
RHR-CF
Indoor Air
Temperature
°C
Advertisement
Table of Contents
