Connection With Remote Control - Lindab RHR-CF Installation Manual

Installation instructions

10.3 Connection with remote control

The control is provided by default fitted on the appli-ance,
however it can also be remoted by fitting it on the wall.
Always disconnect power
before accessing the unit.
1- Remove the controller from the front panel using the
suction cup accessory.
2- Remove the 3-pole connector coupled to the controller.
Fig. 14
1
1a
2
20
Lindab reserves the right to make changes without prior notice
2022-01-28
li n d a b | w e s i m p l i fy c o n s t r u c t ion
3- Unscrew the top cover to access the electric
compartment where the power board is located.
3
4- Remove the cable connected to the CONTROL
connector (terminals 1-2-3) of the power board.
4
CONTROL
1 2 3
5- Perform the new connection to position the con-troller
on the wall, respecting the sequence of the terminal
numbers:
a) apply the supplied cable gland as indicated in the
figure;
b) fix the cable in the cable gland;
c) connect the cable to terminals1-2-3 from the power
board to the controller respecting the numbers
RHR-CF
PG7
CONTROL