Active/Reactive Power Control - Delta RPI-M8 Manual

Vac High Off Slow T
Vac Low Off Slow
Vac Low On Slow
Vac Low Off Slow T
Fac High Off
Fac High On
Fac High Off T
Fac Low Off
Fac Low On
Fac Low Off T
Reconnection Time
7.2.6.4

Active/Reactive Power Control

Only when country sets as Germany LV, Germany MV, Italy LV, or Italy MV can
user enters this page. User has to enter user's password before enter this page.
Settings
21. Jun 2010 13:50
Personal Settings
Coefficients Settings
Install Settings
Active/Reactive Power Control
*1
FRT
*2
*3
The function is same as Vac High Off T, but the time must be
longer than former.
The function is same as Vac Low Off, but the value must be
higher than former.
The function is same as Vac Low On, but the value must be
higher than former.
The function is same as Vac High Off T, but the time must be
longer than former.
Inverter will be disconnected from grid if AC frequency rises to
this value.
Inverter will be reconnected to grid if AC frequency drops to this
value.
If AC frequency reaches to the value of Fac High Off, inverter
will be disconnected in this time.
Inverter will be disconnected from if AC frequency drops to this
value.
Inverter will be reconnected to grid if AC frequency rises to this
value.
If AC frequency reaches to the value of Fac Low Off, inverter
will be disconnected in this time.
The countdown time before inverter connected to grid.
Password
ENT
EXIT
Figure 7-18 Active/Reactive powersetting page
Active/Reactive Power
21. Jun 2010 13:50
Power Limit
ENT
Power vs. Frequency
Constant cosφ
ENT
cosφ(P)
EXIT
Constant Reactive Power
Q(V)
21. Jun 2010 13:50
40