Electrical Safety; Voltage Drops - Stanley FATMAX FME721-QS Manual

The declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms along with the date code are shown
:
on the tool:
Warning! To reduce the risk of injury, the user
O
must read the instruction manual.
Wear safety glasses or goggles
N
6
Wear ear protection
Wear a dust mask.
This product is not to be used by children
under 16.
No Hands Zone - Keep fingers and arms away
from rotational saw blades.
Wear gloves when handling saw blades.
Warning! Laser radiation.
Do not look into the laser beam.
Do not view the laser beam directly with optical
instruments.
LASER LIGHT. LASER RADIATION
Wavelength: 650nm Power: <1mW
DO NOT STARE INTO BEAM.
CLASS 2 LASER PRODUCT.
EN 60825-1 :2007
(Original instructions)

Electrical safety

#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply cor-
responds to the voltage on the rating plate.
Inspect tool cords periodically. If the supply cord is damaged,
it must be replaced by the manufacturer or an authorised
Stanley Fat Max Service Centre in order to avoid a hazard.

Voltage drops

Inrush currents cause short-time voltage drops. Under unfa-
vourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower
than 0.34 Ω, disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Use of an extension cable not suitable for the power input of
the tool or which is damaged or defective may result in a risk
of fire and electric shock.
Features
This tool includes some or all of the following features.
1. Handle
2. Carrying handle
3. Carbon brushes
4. Motor
5. Dust bag
6. Track arm lock knob
7. Stopper pin
8. Track arm guide bars
9. Fence
10. Saw head tilt lock lever
11. Back supporting bracket
12. Side extension table
13. Stock stop
14. Dust extraction adapter
15. Retractable guard
16. Laser
17. Material clamp
18. Turn table
19. Base
20. Table insert
21. Grip for rotating table
22. Height adjustment foot
23. Cutting depth limiter
24. Saw head
25. Shaft lock
ENGLISH
13