Led Indicators; Calibir Gxm640 Led States; Figure 4: Calibir Gxm640 Led Startup Sequence; Table 9: Calibir Gxm640 Led States - Dalsa Calibir GXM640 User Manual

The information contained in this document is not subject to Export Control Regulation in Canada.

LED Indicators

The Calibir GXM640 has one multicolor LED to provide a simple visible indication of
camera state conditions.

Calibir GXM640 LED States

After the Calibir connects to a network and an IP address is assigned, the Status LED will
turn to steady blue. Only at this time will it be possible by the GigE Server or any
application to communicate with the camera. The following table summarizes the LED
states and corresponding camera status.

Table 9: Calibir GXM640 LED States

No power to the camera.
OFF
Initial state on power up before flashing. Remains as steady Red only if there is a
fatal error. Camera is not initialized.
Initialization sequence in progress.
IP address assigned.
Application connected.
Note: Even if the Calibir GXM640 has obtained an IP address, it might be on a
different subnet than the NIC it is attached to. Therefore, if the Calibir LED is blue
but an application cannot see it, this indicates a network configuration problem.
Review troubleshooting suggestions in the Network Imaging manual.
Calibir GXM640 LED States on Power Up
The following LED sequence occurs when the Calibir camera is powered up and connected
to a network.
34  Features and Configuration Options
Red
Power
Green
connected
initializing

Figure 4: Calibir GXM640 LED Startup Sequence

Blue
Light Blue
IP
Application
assigned
connected
Calibir GXM640 IR Camera User's Manual