Dalsa Calibir GXM640 User Manual page 143

The information contained in this document is not subject to Export Control Regulation in Canada.
Click on the NIC where the Calibir camera is connected, and make sure the following
options are enabled / selected:
 Enable Teledyne DALSA DHCP Server;
 Automatic IP (DHCP);
 Sapera Network Imaging Driver Enabled;
 Included in the Discovery Process.
The camera should then be visible to the host computer's software. When placing the
mouse cursor over the GigE Vision Device Status in the system tray, the number of
available devices should be shown:
Double-click the camera icon to show the GigE Vision Device Status window. The Calibir
camera should be listed:
If the camera is not listed, refer to the other information in the Troubleshooting section
for possible solutions.
Calibir GXM640 IR Camera User's Manual Troubleshooting  143