Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly - Canon imagePROGRAF iPF760 Basic Manual

iPF760
• If the paper is jammed by the Ejection Guide
Remove the jammed paper from the Output
Tray.
After removing the paper, make sure there are
no other scraps of paper in the printer.
3
Pull the Release Lever forward.

Roll paper cannot be inserted into the paper feed slot

Roll paper cannot be inserted into the paper feed slot
Cause
The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
Cause
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before
it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
Cut Speed is not configured correctly in the Con-
trol Panel menu.
Basic Guide
Corrective Action
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Corrective Action
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
Roll paper cannot be inserted into the paper feed slot
→P.83
→P.86
Corrective Action
→User's Guide
→P.48
89