Error No.: 300 Is Displayed; Error No.: 1700/1710 Is Displayed - Canon PIXMA MP510 Quick Start Manual

Error No.: 300 Is Displayed

Cause
The machine is not ready.
Machine is not connected properly.
Your machine is not selected in Printer
on the Print dialog box.

Error No.: 1700/1710 Is Displayed

Cause
The ink absorber is almost full.
Make sure that the machine is turned on, and that it is connected securely to the
computer.
If the POWER lamp is off, turn the machine on.
While the POWER lamp is flashing green, the machine is initializing. Wait until
the POWER lamp stops flashing and remains lit green.
When the Alarm lamp is lit orange, an error may have occurred on the machine.
For details on how to resolve the error, see "Error Message Is Displayed on the
LCD" on page 57.
Make sure that the USB cable is plugged in securely to the computer and the
machine.
If you are using a relay device such as a USB hub, disconnect it, connect the
machine directly to the computer, and try printing again. If printing starts
normally, there is a problem with the relay device.
Consult the reseller of the relay device for details.
There could also be a problem with the USB cable. Replace the USB cable
and try printing again.
Select MP510 in Printer on the Print dialog box.
If MP510 does not appear in Printer, follow the procedure below to check that
the driver for your machine is installed to your computer.
(1)Select Print and Fax Preferences from Printer.
In Mac OS X v.10.2.8 or 10.3.x, select Edit Printer List from Printer.
(2)Check that MP510 is displayed in the list of printers and that the check box is
selected.
In Mac OS X v.10.2.8, check that MP510 is displayed in the Printer List.
(3)If MP510 is not displayed, click Add(+) to add the machine.
If you cannot add the machine, follow the procedure described in the Easy
Setup Instructions to reinstall the MP Drivers.
The machine has a built-in ink absorber to hold the ink used during Print Head
Cleaning, for example.
This error message indicates that the ink absorber is nearly full.
Press the OK button to cancel the error so you can continue printing.
However, because printing is disabled once the ink absorber becomes
completely full and until the ink absorber is replaced, you are recommended to
contact a Canon service representative as early as possible. (You will need to
replace a particular part of the machine.)
Action
Action
Troubleshooting 73