Error No.: 300 Is Displayed; Error No.: 1700/1710 Is Displayed - Canon PIXMA iP3300 Series Quick Start Manual

Error No.: 300 Is Displayed

Cause
The printer is not ready.
Printer is not connected properly.
Your printer is not selected in Printer
on the Print dialog box.

Error No.: 1700/1710 Is Displayed

Cause
The ink absorber is almost full.
68 Troubleshooting
Make sure that the printer is turned on, and that it is connected securely to the
computer.
If the POWER lamp is off, turn the printer on.
While the POWER lamp is flashing green, the printer is initializing. Wait until the
POWER lamp stops flashing and remains lit green.
When the ALARM lamp is flashing orange, an error may have occurred on the
printer. For details on how to resolve the error, see "ALARM Lamp Flashes
Orange" on page 65.
Make sure that the USB cable is plugged in securely to the computer and the
printer.
If you are using a relay device such as a USB hub, disconnect it, connect the
printer directly to the computer, and try printing again. If printing starts
normally, there is a problem with the relay device.
Consult the reseller of the relay device for details.
There could also be a problem with the USB cable. Replace the USB cable
and try printing again.
Select iP3300 in Printer on the Print dialog box.
If iP3300 does not appear in Printer, follow the procedure below to check that
the driver for your printer is installed to your computer.
(1)Select Print & Fax Preferences from Printer.
In Mac OS X v.10.2.8 or 10.3.x, select Edit Printer List from Printer.
(2)Check that iP3300 is displayed in the list of printers and that the check box is
selected.
In Mac OS X v.10.2.8, check that iP3300 is displayed in the Printer List.
(3)If iP3300 is not displayed, click Add(+) to add the printer.
If you cannot add the printer, follow the procedure described in the Easy Setup
Instructions to reinstall the printer driver.
The printer has a built-in ink absorber to hold the ink used during Print Head
Cleaning, for example.
This error message indicates that the ink absorber is nearly full.
Press the RESUME/CANCEL button to cancel the error so you can continue
printing.
Before the ink absorber becomes completely full, contact a Canon service
representative. (You will need to replace a particular part of the printer.)
Important
Canon recommends that you call for service as soon as this error occurs. Once
the ink absorber becomes completely full, printing cannot be performed until the
ink absorber is replaced.
Action
Action