Connecting The Scanner To The Projector - Canon imageFORMULA DR-2050SP User Manual

Connecting the Scanner to the Projector

Before connecting the liquid crystal projector, make sure the scanner is not
connected to a PC. The presentation mode cannot be used while the scanner is
connected to a PC.
1.
Make sure the power of the scanner and liquid crystal projector is set to
OFF.
2.
Connect one end of the RGB (Red, Green, Blue) cable (D-sub, 15-pin)
provided with the scanner to the RGB connector of the scanner and
connect the other end to the liquid crystal projector a.
3.
Connect the AC adapter plug to the power connector of the scanner b.
4.
Connect the plug of the power cable to the AC adapter c.
5.
Connect the power plug into the electrical outlet. d
Note
The scanner is automatically set to the "Scanning mode" when it is connected
to a PC. Be sure to disconnect the USB cable connecting the scanner to the PC
in order to use the scanner in the Presentation mode.
16
Setting up the Scanner