Saving Data In The Usb Memory - Canon imageFORMULA DR-2050SP User Manual

• You cannot switch to the USB Memory mode if the USB memory device
cannot be recognized by the scanner, or if there are no image files stored in
the USB memory device.
• When the scanner is in the USB Memory mode and the USB memory device
is disconnected, the scanner automatically switches to the Main Memory
mode. All of the images stored in the main memory are deleted at this time.
• USB devices with security functions, such as password protection, cannot be
used. USB devices that support mass storage class can be used. The scanner
is not guaranteed to be compatible with all USB devices.
• Supported file formats are JPEG, BMP (uncompressed), PNG, and TIFF
(uncompressed, single page). PDF is not supported.
• If the USB memory device contains any large image files, it may take a
while to display the folder (recommended resolution is no more than 150 dpi
for LTR size).

Saving Data in the USB Memory

When the scanner is in the Main Memory mode, press the MODE key on the
remote control or select [Save to USB Memory] from the menu toolbar and
press OK to save the currently displayed image in the USB memory.
Note
• The size of the image files to be saved depends on the "Scanning Size"
setting on the setting toolbar.
• The resolution is set to 150 dpi, file format to JPEG and date/time saved to 1/
1/2007, 10:00AM and they cannot be changed.
• A folder named DR-2050SP/XX (XX is a sequential number 01 – 40) is
created, and a file named DR**.jpg (** is a sequential number 01 – 40) is
saved within the folder.
• USB devices with security functions, such as password protection cannot be
used. USB devices that support mass storage class can be used. The scanner
is not guaranteed to be compatible with all USB devices.
IMPORTANT
The power lamp flashes green while saving images in the USB memory. Do
not attempt to operate the scanner, or disconnect the USB memory while the
lamp is flashing. Doing so may destroy the contents of the memory device.
When the data is successfully saved, the lamp stops flashing. If the data was
not saved, a message appears telling you the data could not be saved in the
USB memory.
29
Using the Scanner