Step 6: Verification Of Settings - Emerson M400 Quick Start Manual
Supervisory controller setup with vfd drive
Hide thumbs
Also See for M400:
- User manual (198 pages) ,
- Quick start quide (36 pages) ,
- Quick start manual (4 pages)
Advertisement
12. From the Details screen, click Commands on the far right and select DRIVE-RESET. The drive is
now reset with the needed configuration.
STEP 6: Verification of Settings
1. After commissioning the new device, verify that the following values are set in the drive:
• 0.009 (MOTOR_PWR_FACTOR) = 0.85 or the value that you set
• 6.004 (Start/Stop Logic) = 6
• 8.023 (Digital input 3) = 0.000
The following parameters must be set up in the Inputs tab to run the drive.
• RUN (ON)
• DIRECTION (FORWARD, REVERSE)
• REF FREQ (the speed setting of the motor)
Document Part # 026-4176 Rev 1
©2022 Emerson Digital Cold Chain, Inc. This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
Figure 18 - Application Commands - DRIVE-RESET
Page 14 of 16
Advertisement
