PRONAR T663/1 Operator's Manual page 130

Pronar T663/1 T663/1 SILO
FIGURE 5.12 Adjustment of drawbar position
(1) drawbar with fixed eye, (2) nut and bolt connection
5.13 TROUBLESHOOTING
TABLE 5.8 Troubleshooting
FAULT
Problem with moving off
Noise in axle hubs
CAUSE
Brake system conduits not
connected
Applied parking brake
Damaged pneumatic
system connection conduits
Leaking connections
Damaged control valve or
brake force regulator
Excessive bearing
slackness
5.36
REMEDY
Connect brake conduits (applies
to pneumatic systems)
Release parking brake.
Replace.
Tighten, replace washers or seal
sets, replace conduits.
Check valve, repair or replace.
Check slackness and adjust if
needed
SECTION 5