Renault MEGANE E-TECH 100% ELECTRIC 2022 User Manual page 254

ACTIVE DRIVER ASSIST
Putting the "Lane centering
assist." function on standby
The "Lane centering assist." function is
put on standby automatically when:
– the Stop and Go adaptive cruise con-
trol is put on standby ➥ 2.83 ;
– the system no longer detects the
lines or only one line is detected in
your lane;
– the lane is too narrow or too wide;
– the system does not detect any
hands on the steering wheel;
– the bend is too sharp;
– in some driving conditions (rounda-
bout, intersection, etc.);
– the vehicle speed is greater than
approximately 93 mph or 100 mph
(150 km/h or 160 km/h), depending
on the vehicle;
– the vehicle speed is below approx-
imately 37 mph (60 km/h), without
any vehicle in front;
– the vehicle touches or breaches a
line;
2.112
(8/15)
– the system is temporarily disrupted
(for example: camera obscured by
dirt, mud, snow,condensation, etc.).
Certain actions carried out by the driver
also suspend the "Lane centering
assist." function:
– activating the indicators;
– too much force is used when han-
dling the steering wheel.
Standby of the function is confirmed by

the 22 warning light and the left-
hand and right-hand line indicators 21
appearing in grey on the instrument
panel.
Important: you should keep
your feet near the pedals
and your hands on the
steering wheel at all times
to prepare for any event.
22
21
Once the conditions are met, the func-
tion again directs the vehicle to the

centre of the lane. The 22
ing light and left-hand and right-hand
line indicators 21 are displayed in green
on the instrument panel.
You can affect the vehicle trajec-
tory at any point by turning the
steering wheel.
21
warn-