Selecting An Input Signal - Canon REALiS SX800 User Manual

■Selecting an Input Signal

1
Press the INPUT button to pop up a window shown at the lower right.
Remote control
The currently active input signal is marked with a circle and highlighted in orange.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray.
In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed in
gray even if they are ready for projection.
When you select [USB] with no PictBridge enabled equip-
ment or an USB flash memory connected and pressing the
OK button, a window waiting for you to connect a Pict-
Bridge enabled equipment or an USB flash memory
appears. For more details, refer to "Projecting an Image
from a Digital Camera (SX80 II)"
ing Data on USB Flash Memory (SX80 II)"
2
The selection is toggled through available input signal types by pressing the INPUT
button.
• You can select the target input signal with [ ] / [ ].
• Only the input signals displayed in white can be selected.
3
Press the OK button to determine the input signal type.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
Top control
(P114 – P117) or "Project-
(P118
55
Selecting an Input Signal (INPUT)
SX80 MarkII
– P124).
SX800