Setting Angle Of Air Flow; Setting Vertical Angle Of Air Flow; Setting Horizontal Angle Of Air Flow; Install The Homewhiz Kit (Wireless Module) - Beko BEVPI 090 User Manual

3 Unit specifications and features

3.6 Setting angle of air flow

3.6.1 Setting vertical angle of air flow

While the unit is on, use the SWING/DIRECT button
on remote control to set the direction (vertical
angle) of airflow. Please refer to the Remote
Control Manual for details.
When using COOL or DRY mode,
do not set louver at too vertical
an angle for long periods of
time. This can cause water to
C
condense on the louver blade,
which will drop on your floor or
furnishings.
When using COOL or HEAT
mode, setting the louver at too
vertical an angle can reduce the
performance of the unit due to
restricted air flow.

3.6.2 Setting horizontal angle of air flow

The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig.B) and
manually adjust it to your preferred direction. For
some units, the horizontal angle of the airflow
can be set by remote control. please refer to the
Remote Control Manual.
3.7 Install the HomeWhiz kit
(wireless module)
1. Remov e the protective cap of the HomeWhiz kit
(wireless module)
2. Open the front panel and insert the HomeWhiz
kit (wireless module) into the reserved interface.
Split Type Air Conditioner / User Manual
Insert
Warning:
A This interface is only
compatible with HomeWhiz kit
(wireless module) provided by
the manufacturer.
3.8 Manual operation (without
remote)
CAUTION! The manual button is
intended for testing purposes and
emergency operation only. Please
do not use this function unless
A
the remote control is lost and it is
absolutely necessary. To restore
regular operation, use the remote
control to activate the unit. Unit
must be turned off before manual
operation.
To operate your unit manually:
1. Open the front panel of the indoor unit.
2. Locate the manual control button on the right-
hand side of the unit.
3. Press the manual control button one time to
activate forced auto mode.
4. Press the manual control button again to
activate forced coolıng mode.
19 / 184 EN