Outdoor Unit Installation; Installation Instructions - Outdoor Unit - Beko BEVPI 090 User Manual

Hide thumbs Also See for BEVPI 090:
Table of Contents

Advertisement

Available languages

Available languages

4 Installation
7. Using even pressure, push down on the bottom
half of the unit. Keep pushing down until the
unit snaps onto the hooks along the bottom of
the mounting plate.
Keep in mind that the hooks on
the mounting plate are smaller
than the holes on the back of
C
the unit. If you find that you don't
have ample room to connect
embedded pipes to the indoor
unit, the unit can be adjusted
left or right by about 30-50 mm
(1.18-1.95in), depending on the
model.
30-50mm
30-50mm
(1.18-1.96in)
(1.18-1.96in)
Move to left or right
Move to left or right

4.3 Outdoor Unit Installation

Install the unit by following local codes and
regulations, there may be differ slightly between
different regions.
Split Type Air Conditioner / User Manual
4.3.1 Installation Instructions – Outdoor
unit
Step 1: Select installation location
Before installing the outdoor unit, you must
choose an appropriate location. The following are
standards that will help you choose an appropriate
location for the unit.
Proper installation locations meet the
following standards:
• Meets all spatial requirements shown in
Installation Space Requirements above.
• Good air circulation and ventilation
• Firm and solid—the location can support the
30-50mm
30-50mm
unit and will not vibrate
(1.18-1.96in)
(1.18-1.96in)
• Noise from the unit will not disturb others
• Protected from prolonged periods of direct
sunlight or rain
• Where snowfall is anticipated, raise the unit
above the base pad to prevent ice buildup and
coil damage. Mount the unit high enough to be
above the average accumulated area snowfall.
The minimum height must be 18 inches.
DO NOT install unit in the following locations:
• Near an obstacle that will block air inlets and
outlets
• Near a public street, crowded areas, or where
noise from the unit will disturb others
• Near animals or plants that will be harmed by
hot air discharge
• Near any source of combustible gas
• In a location that is exposed to large amounts
of dust.
• In a location exposed to a excessive amounts
of salty air.
29 / 184 EN

Advertisement

Table of Contents
loading

Table of Contents