Related Manuals for ProLights Astra Hybrid420
Summary of Contents for ProLights Astra Hybrid420
- Page 1 Astra Hybrid420 Hybrid moving beam-spot, with a 420W USHIO NSL421 lamp USER MANUAL English version REV.01-04/22...
- Page 2 PROLIGHTS product are trademarks OWNED or licensed by Music & Lights S.r.l., its affiliates, and subsidiaries. PROLIGHTS is a registered trademark by Music & Lights S.r.l. All right reserved. Music & Lights – Via A. Olivetti, snc - 04026 - Minturno (LT) ITALY.
-
Page 3: Table Of Contents
18 - ERROR MESSAGES 19 - PERIODICAL CLEANING 20 - GOBOS REPLACEMENT 21 - MAINTENANCE MAINTENANCE AND CLEANING THE PRODUCT............37 REPLACING THE FUSE ....................37 VISUAL CHECK OF PRODUCT HOUSING ..............37 TROUBLESHOOTING ..................... 38 PROLIGHTS - Astra Hybrid420... -
Page 4: Safety Information
• Do not reapply power until repairs have been completed. • Refer any service operation not described in this manual to PROLIGHTS Service team or an authorized PROLIGHTS service center. - Page 5 • Warning! Disconnect the fixture from AC mains power and allow to cool for at least 10 minutes before handling. • Only technicians who are authorized by PROLIGHTS or Authorised service partners are permitted to open the fixture. • Users may carry out external cleaning, following the warnings and instructions pro- vided, but any service operation not described in this manual must be referred to a qualified service technician.
- Page 6 4. This device must accept any interference received, including interference that may cause undesired operation. Other approvals • The product meets the safety requirements of the certification procedures of the market in which it is placed and sold. PROLIGHTS - Astra Hybrid420...
-
Page 7: Packaging
• UPBOX2: Firmware uploader kit, USB IN, 3-pin XLR DMX OUT. 2 - TECHNICAL DRAWING Ø520 mm [20.5 in] 445 mm 310 mm 462 mm [17.5 in] [12.2 in] [18.2 in] Weight: 26.2 kg - 11.88 lbs Fig. 01 PROLIGHTS - Astra Hybrid420... -
Page 8: Pan And Tilt Lock
3 - PAN AND TILT LOCK PAN Mechanism lock and release TILT Mechanism lock and release Fig. 02 PROLIGHTS - Astra Hybrid420... -
Page 9: Installation
Warning! When clamping the fixture to a truss or other structure at any angle, use clamps of half-cou- pler type. Do not use any type of clamp that does not completely encircle the structure when fastened. C6002 RSR0670A/B clamp Steel security cable OS24 108 mm 4.2 in Fig. 03 PROLIGHTS - Astra Hybrid420... -
Page 10: Connection To The Mains Supply
• Connect the power connector into the Mains input socket (100-240 VAC-50/60 Hz). • The product is then ready for its operations and can be controlled through the available input sig- nals on board. • To disconnect power from the product, disconnect the Mains from the socket. PROLIGHTS - Astra Hybrid420... -
Page 11: Product Overview
6. MAIN FUSE HOLDER: replace a burnt-out fuse by one of the same type only (T3.15A 250V). 7. POWER IN: for connection to the Mains 100-240V~/50-60Hz. 8. ANTENNA of Wireless DMX Receiver internal module. 9. PAN Mechanism lock and release. 10. TILT Mechanism lock and release. Fig. 04 PROLIGHTS - Astra Hybrid420... -
Page 12: Dmx Connection
... . DMX IN DMX OUT DMX IN DMX OUT DMX IN DMX OUT DMX IN DMX OUT DMX512 Controller Fig. 06 - Example 25 DMX channels configuration PROLIGHTS - Astra Hybrid420... -
Page 13: Construction Of The Dmx Termination
(Protocol, Net, Subnet, Universe, Start Channel and IP Address, Ethernet to DMX No/Yes). • About the IP addresses is recommended to set 002.xxx.xxx.xxx or 010.xxx.xxx.xxx. • The submask net is fixed at 255.0.0.0. PROLIGHTS - Astra Hybrid420... -
Page 14: Ethernet To Dmx Operations
If the ASTRAHYB420 protocol selected is ArtNet / sACN, the WDMX module will retransmit the DMX values contained in the ArtNet / sACN signal received from the ASTRAHYB420. NOTE: Artnet and sACN have higher priority on DMX if they are connected to transmitter. PROLIGHTS - Astra Hybrid420... -
Page 15: Operation As A Wireless Receiver
• The wireless icon on the receiver display indicates the received signal strength. WDMX TO DMX (RX) This function enable or disable the retransmission of the wireless DMX signal received throught the DMX port on the receiver side. PROLIGHTS - Astra Hybrid420... -
Page 16: Control Panel
• Used to access the menu tree or to return a previous menu window. • To switch on the display throught the battery. • LED indicator for Wireless dmx (color red and green). • LED indicator for Ethernet network.(color orange). PROLIGHTS - Astra Hybrid420... -
Page 17: Menu Structure
Set Universe for ArtNet protocol. sACN SETTINGS IP ADDRESS Set IP address of the fixture. UNIVERSE Set Universe for sACN protocol. OFF/HTP/ MERGE MODE Merge Mode sACN protocol. ETHERNET TO Enable Disable retrasmission from sACN/ArtNet signal to DMX out port. PROLIGHTS - Astra Hybrid420... - Page 18 INVERT ZOOM Invert zoom values. TRANSFER WITHOUT DMX To transfer the same menu CONFIGURATION ADDRESS settings of one fixtures to all the other in the daisy chain, WITH DMX including or not the dmx ADDRESS address. PROLIGHTS - Astra Hybrid420...
- Page 19 PAN, TILT... To see any error messages. MESSAGE FIXTURE XXXXXXXXXX View informations about fixture MODEL model. RDM UID (READ ONLY) View ID for the RDM control. SOFTWARE 1U01 V1.0.00... View informations about soft- VERSION ware version. PROLIGHTS - Astra Hybrid420...
-
Page 20: Shortcut
Directly flip display without enter inside menu. after power on DOWN Reset without Fixture will be powered on without reset on pan/tilt then power on pan/tilt movements movements. ENTER + UP Bootloader Force firmware upgrade. then power on PROLIGHTS - Astra Hybrid420... -
Page 21: Rdm Functions
0x0140 DMX_FAIL_MODE 0x0141 DMX_STARTUP_MODE 0x0142 Dimmer DIMMER_INFO 0x0340 Settings MINIMUM_LEVEL 0x0341 MAXIMUM_LEVEL 0x0342 CURVE 0x0343 CURVE_DESCRIPTION 0x0344 OUTPUT_RESPONSE_TIME 0x0345 OUTPUT_RESPONSE_TIME_ DESCRIPTION 0x0346 MODULATION_FREQUENCY 0x0347 MODULATION_FREQUENCY_ DESCRIPTION 0x0348 Sensors SENSOR_DEFINITION 0x0200 SENSOR_VALUE 0x0201 RECORD_SENSORS 0x0202 BURN_IN 0x0440 PROLIGHTS - Astra Hybrid420... - Page 22 IPV4_STATIC_ADDRESS 0x0706 Custom Pids FIX. ENGINE PROT. (0:W/DMX 1:sACN 0x8010 2:ArtNet) PIX. ENGINE PROT. (0:W/DMX 1:sACN 0x8020 2:ArtNet 3:sAK 4:ArtK) PIX. ENGINE ADDR. (1-512) 0x8030 PIX. ENGINE MODE (0:Off 1:Ring 2:Pixel) 0x8040 KLINGNET (0:Off 1:On) 0x8050 PROLIGHTS - Astra Hybrid420...
-
Page 23: Dmx Charts
Rot Gobo Rotation Fine Fixed Gogo 4f Circular Prism 4f Circular Prism Insertion 8f Circular Prism 8f Circular Prism Insertion Frost Zoom Zoom Fine Focus Focus Fine Animation Insertion Animation Rotation Beam / Spot Filter Control PROLIGHTS - Astra Hybrid420... - Page 24 126 ÷ 139 Dark Red 140 ÷ 153 Dark Red + Open 154 ÷ 167 Forward Spin From fast to slow 168 ÷ 210 Stop Stop 211 ÷ 212 Reverse Spin From slow to fast 213 ÷ 255 PROLIGHTS - Astra Hybrid420...
- Page 25 Lineary from 0° to 360° 000 ÷ 127 Forward Spin From fast to slow 128 ÷ 190 Stop Stop 191 ÷ 192 Reverse Spin From slow to fast 193 ÷ 255 R. GOBO ROTATION FINE 000 ÷ 255 PROLIGHTS - Astra Hybrid420...
- Page 26 8F CIRCULAR PRISM ROTATION Indexed Lineary from 0° to 360° 000 ÷ 127 Forward Spin From fast to slow 128 ÷ 190 Stop Stop 191 ÷ 192 Reverse Spin From slow to fast 193 ÷ 255 PROLIGHTS - Astra Hybrid420...
- Page 27 082 ÷ 083 NO SIGNAL BLACKOUT 084 ÷ 085 STATUS LED ON 086 ÷ 087 STATUS LED OFF 088 ÷ 089 INVERT ZOOM OFF 090 ÷ 091 INVERT ZOOM ON 092 ÷ 093 RESET ALL 094 ÷ 095 PROLIGHTS - Astra Hybrid420...
- Page 28 RESET FROST 126 ÷ 127 RESET SHUTTER 128 ÷ 129 RESET OTHER 130 ÷ 131 LAMP OFF 132 ÷ 133 LAMP ON 134 ÷ 135 Reserved 136 ÷ 253 FACTORY DEFAULT OF CONTROL FUNCTIONS 254 ÷ 255 PROLIGHTS - Astra Hybrid420...
-
Page 29: Fixed Gobos Wheel
14 - FIXED GOBOS WHEEL Open Fig. 09 PROLIGHTS - Astra Hybrid420... -
Page 30: Rotating Gobos Wheel
• Ø of image (ID)= 12 mm • Thinckness= 1.1 mm Slot 02 Slot 03 Slot 01 Slot 04 Open Slot 05 Slot 09 Slot 06 Slot 08 Slot 07 ATTENTION! Load with mirror surface toward the light source. Fig. 10 PROLIGHTS - Astra Hybrid420... -
Page 31: Color Wheel
CYAN - COLOR WHEEL 1 MAGENTA - COLOR WHEEL 2 DARK GREEN LAVANDER 3200K DARK BLUE 2500K H.M.GREEN BLUE DARK WOOD YELLOW - COLOR WHEEL 3 LIGHT GREEN PINK AQUAMARINE DARK ORANGE LIGHT ORANGE Fig. 11 PROLIGHTS - Astra Hybrid420... -
Page 32: Lamp Replacement
Carefully remove any debris found on gasket and screw holes of the heatsink module using a nonabra- sive brush before installing! Carefully inspect gaskets for signs of wear such as cracking or hardening, deformities, or alignment issues before replacing the lamp. Then insert the new lamp using the reverse procedure. Fig. 12 PROLIGHTS - Astra Hybrid420... -
Page 33: Centering System Of The Lamp
WARNING! Never touch the lens and use the goggles. Move the screwdriver upwards, downwards, right or left into a marked slot (1) to center the hotspot of the lamp on the center of the projection (2). Fig. 13 PROLIGHTS - Astra Hybrid420... -
Page 34: Error Messages
Magenta flag of the CMY module is not located Yellow in its default position Failure detected during the reset of the Yellow flag, if [YELLOW ERROR] the Yellow flag of the CMY module is not located in its Yellow default position PROLIGHTS - Astra Hybrid420... - Page 35 This error message indicates that an overheating [IGNITOR TEMPERATURE on the ignitor has occurred and the lamp has been Acquamarine ERROR] switched OFF by the product protection system. [LAMP TEMP. SENSOR LAMP sensor damaged (open or in short circuit) Acquamarine ERROR] PROLIGHTS - Astra Hybrid420...
- Page 36 IDENTIFICATION OF ELECTRONIC BOARDS 3U PCB 2U PCB 1U PCB 5U PCB 4U PCB Fig. 14 PROLIGHTS - Astra Hybrid420...
-
Page 37: Periodical Cleaning
Loosen the marked screws and opening the head covers (2) from both sides. Use a soft cloth dampened with any detergent liquid for cleaning glass to remove the dirt from the reflectors, the lenses and filters. Fig. 15 PROLIGHTS - Astra Hybrid420... -
Page 38: Gobos Replacement
Loosen the marked screws and opening the head cover (see the "PERIODICAL CLEANING" paragraph, point 2). Detach the gobo holder flap from the gobo wheel (2). Then remove the gobo holder (3). Remove the spring (4) and the gobo (5). Fig. 16 PROLIGHTS - Astra Hybrid420... -
Page 39: Maintenance
WARNING: the use of alcohol or any other detergent could damage the lenses. • All other service operations on the product must be carried out by PROLIGHTS, its approved service agents or trained and qualified personnel. -
Page 40: Troubleshooting
• Check if the Fuse is intact and eventually replace it if fault. necessary. • Contact the PROLIGHTS Service or authorized service partner. Do not remove parts and/or covers, or carry out any repairs or service that are not described in... - Page 41 Note...
- Page 42 Note...
- Page 44 PROLIGHTS is a trademark of prolights.it Via A.Olivetti snc MUSIC & LIGHTS S.r.l. support@prolights.it 04026 - Minturno (LT) ITALY musiclights.it Tel: +39 0771 72190...