Table of Contents
Advertisement
Two Rear Auxiliary Storage Drives
Two 2.5" hot-swap SATA drive bays are available on the chassis rear. These can be replaced
using the same procedure as the front drives.
Two SATA Drives
M.2 Solid State Drives
Up to two M.2 solid state drives (SSDs) can be installed on the RSC-UMR-8 riser card, with
some restrictions. One M.2 socket supports PCIe and one supports SATA.
Several SSD lengths are supported—42mm, 60mm 80mm or 110mm. For each length, there
is an hole in the storage adapter card for a plastic standoff. The following combinations are
supported:
•
Two 42 or 60 mm
•
One 42 and one 80 mm
•
One 110 mm
To install two M.2 SSDs, you must order another standoff (P/N FST-SCRW-0074L)
SSD SATA
Holes for Standoffs
(choose one or two)
Socket
If using the M.2 SATA socket, connect the optional cable, CBL-SAST-0538, to the motherboard
at connectors S-SATA4 or S-SATA5.
Chapter 3: Maintenance and Component Installation
Figure 3-7. Rear Drives
Figure 3-8. M.2 SSDs on the Riser Card
49
SSD PCI-E
Socket
Advertisement
Table of Contents
