Supermicro SuperServer SYS-2029U-TN24R4T User Manual page 97

SATA HDD Unlock
Select Enable to unlock the HDD password. The options are Disable and Enable.
Aggressive Link Power Management
When this item is set to Enable, the SATA AHCI controller manages the power usage of the
SATA link. The controller will put the link to a low power state when the I/O is inactive for an
extended period of time, and the power state will return to normal when the I/O becomes
active. The options are Disable and Enable.
*If the item above "Configure sSATA as" is set to AHCI, the following items will be
displayed:
sSATA Port 0~ Port 5
This item displays the information detected on the installed SATA drive on the particular SATA
port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (sSATA Port 0~ Port 5)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (sSATA Port 0~ Port 5)
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
sSATA Device Type (sSATA Port 0~ Port 5)
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
*If the item above "Configure SATA as" is set to RAID, the following items will be
displayed:
sSATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0~ Port 5
This item displays the information detected on the installed SATA drive on the particular SATA
port.
•
Model number of drive and capacity
97
Chapter 6: BIOS