Maintenance - BorMann PRO BBP4015 Manual

EN
CAUTION: See the following chart for ratio information that is useful when diluting chemicals.
CAUTION: Never spray chemicals undiluted.
CAUTION: When using a water dispersible powder, etc., dissolve thoroughly in a container such as a bucket.
Chemical
Water
4 L
6 L
8 L
10 L
12 L
15 L
Main plant diseases and pests
Always adhere to chemical manufacturer instructions when handling chemicals. Thoroughly dissolve chemical prior to use.
Chemical replenishment
Check to make sure the sprayer switch is OFF and replenish chemical tank with mixed chemical.
When filling tank with chemical, always strain chemical through equipped tank strainer. The side of
the chemical tank is marked with scale divisions, so be sure to use these as operation guidelines.
Firmly tighten chemical tank lid to prevent leaking.

Maintenance

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should
be performed by Bormann Pro Authorized or Factory Service Centers, always using Bormann Pro
replacement parts.
After-use maintenance
• After use, remove residual liquid from chemical tank, and wash away clinging chemical from inside
of tank using clean water.
• Now fill up chemical tank with clean water and run the sprayer for 2 to 3 minutes to wash out
residual chemical from the pump, hose, and nozzle, etc.
• Remove the residual liquid from inside the chemical tank, restart the pump, and run the sprayer
until residual liquid ceases to come out of the nozzle, and then turn sprayer switch OFF.
• Wipe away moisture and dirt from equipment, and then check for damage and leaks.
Daily checks
• Before work, check to see whether or not fastened units are loose and components are missing.
• Check to make sure the spray hose is not cracked, worn and/or damaged.
• After use, always be sure to wipe dirt off of exterior, and to check for damage and/or leaks.
Cleaning water absorption strainer
1. After removing chemical from tank, remove the water absorption strainer at the bottom of the
tank.
2. Open the cap and remove dirt and debris from the inside of the strainer.
12
500
8 mL
12 mL
16 mL
20 mL
24 mL
30 mL
WWW.BORMANNTOOLS.COM
Dilution ratio
1,000
4 mL
6 mL
8 mL
10 mL
12 mL
15 mL
CAUTION: When changing chemical, be sure to
carefully wash the tank, pump, and nozzle, etc.
with clean water. Residue of the previous chemi-
cal may cause a spray injury. Moreover, if chem-
icals mix, a chemical change may occur, with the
danger of generating a toxic gas.
CAUTION: Be sure to wear protective gloves.
CAUTION: Do not change chemical in poorly ven-
tilated locale. (prevent chemical poisoning).
CAUTION: Always be sure that the tool is switched
off and battery cartridge is removed before at-
tempting to perform inspection or maintenance.
CAUTION: For inspection and maintenance, al-
ways wear protective gloves.
NOTICE: Never use gasoline, benzine, thinner, al-
cohol or the like. Discolouration, deformation or
cracks may result.
CAUTION: Pull out the strainer carefully make
sure not to snap the water hose.
2,000
2 mL
3 mL
4 mL
5 mL
6 mL
7.5 mL