Table of Contents
Advertisement
4.
Locations and functions
4.1.
Locations and functions
1 Lens mount
2 Camera Link connector 1
3 Camera Link connector 2
4 12-pin Hirose connector
5 DIP switch
6 Button
7 LED indicator
8 Camera mounting holes
*1) Note:
Rear protrusion on M52 mount lens must be less than 13mm.
F mount is also available. Rear protrusion for F mount lens is the same as M52 mount.
*2) Note:
When a Camera Link
screws by using a driver. The Camera Link receptacle on the camera might be damaged.
For security, the strength to tighten screws is less than 0.291 Newton meter (Nm).
Tightening by hand is sufficient in order to achieve this.
*3) Note:
The depth of mounting hole is 5 mm. If the longer screws than 5 mm are used, they may
damage the circuit board inside.
LQ-201CL
Fig. 1 Location of external features
M52 mount (*1)Note)
base connector (1) (*2)Note)
medium connector (2) (*2)Note)
DC +12, External trigger and RS-232C
SW-1 ( refer to chapter 4.2 for the details)
For one-push auto white balance (Gain based)
Power, trigger input and operation indications
8 x M3, depth 5mm (*3) Note)
TM
cable is connected to the camera, please do not excessively tighten
8
Advertisement
Table of Contents
