Table of Contents
Advertisement
7.6
Command AW – Activate One-Push Auto White Balance (AWB) - Gain
By sending this command via the serial communication, the gain based One-Push AWB function is
activated. This function can also be initiated by pressing the rear panel button. The white balance
function takes approximately 3 seconds to complete. During this time the rear panel LED will show
orange.
This function operates in two steps. First the red-to-green channel difference and the blue-to-green
channel difference are calculated separately. Then the gains of the blue and red channels are
automatically adjusted, to obtain the same output level on all three channels.
Settings:
Applicable modes:
Associated functions:
Note:
When color temperature of illumination exceeds the range of adjustment, proper white
balance may not be obtained.
The data can be stored in camera memory for use at next start up.
This function can work in external trigger mode.
The S/N ratio of the output will change as a result of this function.
7.7
Command BA – Bit Allocation
This function lets the user select whether the video data is presented as 4 x 8 (32)-bit or 4 x 10
(40)-bit in the Camera Link output. The internal processing in the camera is based on a 12-bit A/D
signal. The 32-bit and 40-bit function removes the least significant bits from the 12-bit signal.
Settings:
Applicable modes:
7.8
Command BI – Binning
This function reduces the number of pixels to 2048 without affecting the line rate. Two adjacent
pixels are combined at the output stage and read out as one pixel. Sensitivity is doubled as a result
of binning.
Settings:
Applicable modes:
Note
Setting data is stored in camera memory for use at next start up
This function is available for all modes.
LQ-201CL
0 = activate automatic process
All
Command WB
Rear panel one-push WB button.
0= 4 x 8-bit, 1= 4 x 10-bit
All
1=binning on, 0=binning off
All
44
Advertisement
Table of Contents
