Command Ga - Master Gain Level; Commands Gar, Gab And Gair - Gain Level Red, Blue And Nir; Command Gm - Gain Mode; Command Hpfc - Aperture Control - JAI LQ-201CL User Manual

Settings:
Associated functions:
Applicable modes:
7.14 Command GA – Master Gain Level
This function is a global gain adjustment for all channels. There are two ways to adjust gain: one is
"Master Tracking" and the other is "Individual". Command GM selects a required mode. The gain
setting is done in the analog domain where 1LSB equals 0.01dB.
Master Tracking
Settings:
Individual
Settings:
Associated functions:
7.15 Commands GAR, GAB and GAIR – Gain Level Red, Blue and NIR.
In conjunction with the Command GA, this function allows the individual setting of gain for
all channels, or it can be used for fine adjustment after one push white balance is
executed. It is important to note that increasing the gain will lead to an increased noise
level and reduced S/N-Ratio.
Master Tracking
Settings:
Individual
Settings:
Associated function:
Applicable modes:
Note: Setting data is stored in camera memory for use at next start up
7.16

Command GM - Gain Mode

Selects gain mode.
Settings:
7.17 Command HPFC – Aperture Control
This command enables Aperture Correction to enhance the edge of the picture. The level is pre-set
in the factory.
Settings:
7.18

Command LR - Line Rate (Scan Rate)

This function is used only when there is not an external trigger pulse (e.g. from an encoder)
LQ-201CL
0= OFF(independent R, G,B and NIR settings)
1= R, B and NIR channel tracking with G
Commands PER, PEG, PEB and PEIR – Programmable Exposure
Shutter-Select mode only
Master (G): 0 to 802
G: -402 to 1404
Commands GAR, GAB, GAIR - Gain level red, blue, and NIR.
-402 to 602(-4dB to +6dB)
-402 to 1404 (-4dB to +14dB)
Command GA – Master gain level
All modes
0=Master Tracking (Factory default)
1=Individual
0= OFF, 1= ON
46