Heartway Medical Products S11E User Manual page 21

According to the battery type and condition of the batteries, batteries usually can be
fully charged in 4‐10 hours.
This will be indicated when the status light in the battery charger side panel turns green.
Charging the battery longer than necessary will not harm the battery.
We recommended that you charge the batteries for 8 to 10 hours after daily use. Do not
charge the batteries for more than 24 hours.
Note: There is a battery circuit diagram labeled on the frame. Please refer this diagram
before you assemble the battery.
BATTERY MAINTENANCE INSTRUCTION
 Read through the charger operating instruction before using it.
 Make sure you charge the battery every time after you use the power scooter or
scooter.
 If the charger indicates red light, please kindly check if the charger is defected or
if the cable wiring connection is poor.
 Please keep the battery terminals clean otherwise the charging condition will be poor.
Caution
Caution on usage of Lithium Ion pack. (or soft pack)
Handing at assembly
1) In case of adding strong shock to battery or dropping battery, do not use the battery.
2) In case of distorting battery, do not use the battery.
3) To prevent from ESD under appropriate work environment and by workers.
Storage
1) It shall be kept in shipping condition (within 40%~60% SOC or 25V~26V voltage
range) for long period.
2) It is recommended to inspect the battery pack every 6 month to ensure battery pack is
at the best status for long term storage. If battery pack is out of the storage condition,
specified in 1), it shall be charged or discharged to the recommended storage condition.
3) It shall be kept in dry condition of low humidity, especially be free from high
temperature.
4) Do not storage the battery near heat sources, nor in a place subject to direct sunlight to
storage in warehouse.
Prohibition Clause
1) Do not throw the battery into fire, nor heat the battery.
2) Do not disassemble nor modify the battery Pack.
3) Do not leave the battery in a place of high temperature.( 45ºC or more)
4) Do not immerse battery in water, nor leaving in high moisture.
5) Do not add strong shock, nor drop the battery.
6) Do not solder lead directly to the battery body.
7) Do not heat nor solder the terminals of the battery.
19