Catalyser Removal; Catalyser Temperature Sensor Removal - Miele H350 Technical Information

Novotronic Models
5.28 Catalyser - Removal (Pyrolytic/Self-Cleaning
Models)
1. Perform door removal procedure
2. Perform oven removal
3. Perform front cover removal
4. Perform rear cover removal
5. Remove the control module mounting screw
6. Unclip the control module and slide it forwards slightly so that the vent
duct retaining screw is accessible
7. Remove the vent duct retaining screw
8. Remove the vent duct
9. Remove the catalyser Pt 1000 temperature sensor mounting screw
10. Remove the catalyser Pt 1000 temperature sensor
11. Perform shelf runner removal
12. Remove the roof/grill heater element retainer and tilt the roof/grill
heating element downwards
13. Remove the catalyser mounting nuts from the interior of the oven
14. Disconnect the catalyser heating element
15. Remove the catalyser upwards
5.29 Catalyser Temperature Sensor - Removal
(Pyrolytic/Self-Cleaning Models)
1. Perform door removal procedure
2. Perform oven removal
3. Perform front cover removal
4. Perform rear cover removal
5. Remove the catalyser PT 1000 temperature sensor mounting screw
6. Remove the catalyser PT 1000 temperature sensor
7.
Disconnect the Pt 1000 temperature sensor connections at the
electronic unit
Note:
Cut through the wiring harness ties. New wiring harness ties are
supplied with a new Pt 1000 sensor
49
Technical Information