Adding Or Removing A Memory Module - HP Compaq dc7100 DT Hardware Reference Manual

Hardware Upgrades

Adding or Removing a Memory Module

Ä
Ä
Ä
Å
2–14
CAUTION: The memory module sockets have gold-plated metal contacts.
When upgrading the memory, it is important to use memory modules with
gold-plated metal contacts to prevent corrosion and/or oxidation resulting
from having incompatible metals in contact with each other.
CAUTION: Static electricity can damage the electronic components of
the computer. Before beginning these procedures, ensure that you are
discharged of static electricity by briefly touching a grounded metal
object. See Appendix D, "Electrostatic Discharge"
CAUTION: When handling a memory module, be careful not to touch
any of the contacts. Doing so may damage the module.
1. If the Smart Cover Sensor is enabled, restart the computer and
enter Computer Setup to disable it.
2. Turn off the computer properly through the operating system,
then turn off any external devices.
3. Disconnect the power cord from the power outlet and the
computer, and disconnect any external devices.
4. Position the computer on its side with the rubber pads on the
bottom. (If the computer is being used in the tower configuration,
remove the computer from the stand. Refer to
Removing the Tower Stand" on page 2–7
5. Remove the access panel. Refer to
Access Panel" on page 2–1
6. Locate the memory module sockets on the system board.
WARNING: To reduce the risk of personal injury from hot surfaces,
allow the internal system components to cool before touching.
www.hp.com
for more information.
"Attaching and
for more information.)
"Removing and Replacing the
for more information.
Hardware Reference Guide