Hardware Upgrades
✎
2–26
13. Connect the data cable to the data connector on the system board.
The replacement hard drive kit includes several data cables. Be sure
to use the cable that is exactly the same as the factory-installed cable.
14. Connect the data cable 1 and power cable 2 to the new hard
drive.
Data 1 and Power 2 Cable Connector Locations
15. Gently place the left side of the hard drive in place, then rotate the
right side of the drive down until it locks.
16. Replace the front bezel and MultiBay assembly.
17. Replace the access panel.
18. Replace the stand, if desired.
19. Reconnect all external devices, plug the power cord into the
power outlet, and turn the computer on.
20. Use Computer Setup to enable the Smart Cover Sensor, if desired.
www.hp.com
Hardware Reference Guide