Chapter Ii Vertical System; Setting Coupling Channel - UNI-T UTD2052CL+ User Manual

Digital oscilloscope
Hide thumbs Also See for UTD2052CL+:
Table of Contents

Advertisement

Chapter II
UTD2000 series DSO provides two analog input channels, each channel has an
independent vertical menu. Each channel for UTD2000 series DSO can be set
independently through the vertical system menu. After pressing CH1 or CH2 function key,
the system shall display function menu of CH1 or CH2 channel. See Table 2-1 below for
description.
Function Menu
Setting
AC
Coupling
DC
GND
20MHz
BW Limit
Full BW
Coarse
Volts/Div
Fine
0.01×
0.02×
Probe
...
100×
1000×
——
Next page
ON
Invert
OFF
Function Menu
Setting
Invert
OFF
ON
Unit
V,A
——
Back to

2.1 Setting coupling channel

If the measured signal connected to the CH1 channel is a sinusoidal signal containing DC
component. If your press F1 to select as AC coupling, to set the CH1 into AC coupling
mode. Then the DC component of the measured signal is blocked. Waveform display is
shown in figure below.
Vertical System
Table 2-1 Channel Menu (Page 1)
Description
Block the DC component of input signal.
Pass through DC and AC components of input signal.
Display grounding level (Input signal is not disconnected).
Limit bandwidth to 20MHz to reduce high-frequency component of detected
signal.
Turn off bandwidth limit, the DSO runs through full bandwidth.
Set vertical scale of current channel based on 1-2-5 scale.
Fine Volts/Div is within the range of coarse Volts/Div setting, set the vertical scale
of current channel based on 1% step of current Volts/Div scale.
Based on probe attenuation coefficient, you select a value to ensure the
consistency of vertical scale reading and actual displayed waveform so that you
don't need to calculate by multiplying the probe attenuation coefficient.
Go to next page
Activate reverse function of waveform. Waveform will be displayed reversely.
Waveform is displayed normally.
Table 2-2 Channel Menu (Page 2)
Description
Display normal waveform
Display waveform invert
Display the unit of current channel range
Go back to previous page
17
UTD2000 Series User Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents