Cursor Measurement - UNI-T UTD1025CL Manual

UTD1000L User Manual
/
8. Press left right key to select storage position
;
as 1
.
9 Press key F3 to callback, Load Success
indicated on screen means callback successful and
waveform shall appear on screen
10. Press key F4 to close reference waveform.

Cursor Measurement

To callback waveform under the following steps:
1. Press key SHIFT and character shift will
appear on the right upper corner of screen
2. Press key to enter into cursor set menu
3. Press key F3 to select cursor measurement
;
type
There are two cursor measurement types in cursor
measurement menu: voltage and time.
In measuring voltage, you can use key SELECT
/ /
on board and up down left right key to adjust
cursor position respectively it means to
,
measure ΔV if select time
;
;
;
/
,
, .
you can measure Δt
Voltage/time measurement method: when cursor
1or 2 appear at the same time adjust cursor
/
position with the up down left right key and
press key SELECT to select cursor Reading
displayed shall be voltage or time value between
the two cursors.
If cursor function is open, measurement value shall
appear automatically on the left upper corner of
.
screen
Picture 6-28 Time Cursor Measurement Menu
,
/ /
.
71