Troubleshooting - ElectrIQ A1/CMAC10M User Manual

TROUBLESHOOTING

Do not repair or disassemble the air conditioning. Unqualified repair will invalidate the warranty and may lead to failure, causing
injuries and property damage. Only use it as directed in this user manual and only perform operations advised here.
Problems
The air
conditioner does
not work.
The cooling
effect is not good
Loud Noise
Compressor does
not work.
Others
If problems not listed in the table occur or recommended solutions do not work, please contact the service
centre.
APPENDIX
Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste
must be handled separately as special treatment is necessary. Recycling facilities are now
available for all customers at which you can deposit your old electrical products. Customers
will be able to take any old electrical equipment to participating civic amenity sites run by
their local councils. Please remember that this equipment will be further handled during
the recycling process, so please be considerate when depositing your equipment. Please
contact the local council for details of your local household waste recycling centres.
Reasons
There is no electricity.
FULL indicator is illuminated
The ambient temperature is too low or
too high
In cooling mode, the room temperature is
lower than the desired temperature
In dry mode, the ambient temperature is
low.
There is direct sunlight.
Doors or windows are open; there are a
lot of people; or in cooling mode, there
are other sources of heat (e.g. fridges)
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on a flat
surface.
Overheat protection starts.
No refrigerant or there is very little
refrigerant
Anti-freezing protection
High pressure protection
Solutions
Turn it on after connecting it to a socket with
electricity.
Discharge the water inside.
Only use to use the machine within temperature
⁰C
range of 18-45
Change the desired temperature.
The ambient temperature must be above 18 ⁰C.
(60 ⁰F).
Use curtains to reduce the direct sun heat
Close doors and windows; increase air
conditioning power
Clean or replace the filter screen.
Clear obstructions; make sure venting is correct as
described in this user manual and hose is not bent
Put the air conditioning on a flat and hard place
(to reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
Refer to Service Centre (check leakage, wielding,
vacuum pump, charge refrigerant according to
name plate)
Waiting for defrosting.
Function will recover automatically. No user input
needed.
After inside gas pressure comes down, it will
function normally. No user input needed
9