System Debugging; Establishing The Configuration Environment - QTech QSW-6900-56LF Series Hardware Installation And Reference Manual

Table of Contents

Installation Manual

4. System Debugging

4 SYSTEM DEBUGGING

Establishing the Configuration Environment

Connect the PC to the console port of the switch through the console cable, as shown in Figure

4-1.

Figure 4-1 Schematic diagram of the configuration environment

Connecting the Console Cable

1. Connect one end of the DB-9 jack of the console cable to the serial port of the PC.

2. Connect one end of the console cable RJ45 to the console port of the switch.

Setting Terminal Parameters

❖ Step One: Start the PC and run the terminal simulation program on the PC, such as Terminal

on Windows 3.1 or HyperTerminal on Windows 95/98/NT/2000/XP.

❖ Step Two: Set terminal parameters. The parameters are as follows: baud rate 9600, data bit

8, parity check none, stop bit 1, and flow control none. Details are as follows:

Choose Start > Programs > Accessories > Communications > Hyperterminal.

Choose Cancel. The Connection Description window appears as shown in Figure 4-2.

Figure 4-2

www.qtech.ru

Table of Contents