QTech QSW-6900-56LF Series Hardware Installation And Reference Manual page 20

Installation Manual
3. Product Installation
The mounting brackets are located at the four of the six screw holes at both sides on the
back panel of the host.
Distinguish the left and the right rear brackets according to the marked directions.
The rear brackets provided are only applicable for cabinets with depth of 800mm - 1200mm.
Mounting the Switch to a Workbench
In some cases, users do not have the 19-inch standard cabinet. The common solution is to place
the switch on a clean workbench. The operation is simple as follows:
Attach the four rubber pads to the four corners on the switch bottom.
Place the switch on the workbench and ensure good ventilation condition around the switch.
Figure 3-3 Mounting the Switch on a Workbench
www.qtech.ru
20