To The Installer - Honeywell VISTA-250FBPT Installation And Setup Manual

Other System Messages
Display Description
COMM
Indicates a failure occurred in the telephone communication portion of your system.
FAILURE
LO BAT
Indicates a low-battery condition exists in the wireless transmitter displayed. Pressing any key silences the
audible warning sound.
SYSTEM This indicates that a low-battery condition exists with the system's backup battery.
LO BAT
HSENS Indicates a smoke detector with a high sensitivity level, which may cause a false alarm. The detector should
be cleaned or replaced.
LSENS
Indicates a smoke detector with a low sensitivity level. The detector may not detect a smoke condition. The
detector should be cleaned or replaced.
RCVR Indicates the system has more wireless zones programmed than the RF receiver can support. If this is not
SETUP
corrected, none of the zones in the system will be protected. If additional wireless zones are desired, use an
ERROR appropriate receiver.
MODEM This indicates that the control is on-line with a remote computer.
COMM
System Off-Normal Report
If programmed, an Off-Normal report is generated instead of the periodic test report if any of the following conditions
are present at the time of the report:
Fire trouble on any zone (zone types 9, 16, 17, 18)
•
Fire supervisory present (zone type 18)
•
Unrestored fire alarm on any zone
•
Bypass of any fire zone
•
A fault for any supervised fire Notification Appliance Circuit
•
Bypass/disable of any supervised fire Notification Appliance Circuit
•
Telco fault of either dialer line
•
Bypass/disable of either dialer line
•
Earth ground fault
•
Bypass of earth ground supervisory zone
•
Fault on LORRA "XMIT OK" signal (if enabled)
•
LORRA trigger bypassed
•
AC failure
•
Low system battery
•
Keypad supervision fault
•
The Off-Normal report is sent as follows:
Contact ID: Code 608
•
High Speed: Channel 3 of system report used (channel 9=6)
•
Express Speed: Digits programmed in System Group #4 report codes
•

To the Installer

Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to the user as
well as acquainting the user with the proper operation and limitations of the alarm system and its component parts.
Recommendations must be included for a specific program of frequent testing (at least weekly) to ensure the system's
proper operation at all times.
Turning the System over to the User
Fully explain the operation of the system to the user by going over each of its functions, as well as the User Guide
supplied.
In particular, explain the operation of each zone (entry/exit, perimeter, interior, fire, etc.). Be sure the user understands
how to operate any emergency feature(s) programmed into the system.
73