HIKVISION HiLook PTZ-T5225I-A User Manual page 31

DVR to 15s, corresponding to the dome it would be 140s. Refer to the interface for more details.
However, if you select EQUAL, they will be exactly the same.
4. Edit the patrol.
Steps:
(1) Move the cursor to EDIT PATROL and click IRIS+ to enter editing mode.
(2) Click up/down direction buttons to choose the number and locate the preset to be edited.
(3) Click left/right direction buttons to position the cursor to the column of PRESET, DWELL and
SPEED. You can click the up/down direction buttons to set the value of preset number, dwell
time and patrol speed.
The presets you set for a patrol should be the ones that have been pre-defined by users.
The dwell time is the time that the speed dome stays on a certain preset; the patrol
speed is the scanning speed the speed dome switching between the presets.
(4) Follow the above steps to define the other presets for the selected patrol. Press IRIS+ to save
the new settings or press IRIS- to cancel and return to the previous menu.
5. Preview the patrol.
Move the cursor to PREVIEW and click IRIS+ to preview the current patrol. You can click IRS+
again to stop the preview.
6. Call the defined patrol.
You can call the special presets to call the defined patrol. E.g. call preset 35 to call patrol 1.
Please refer to Section 2.3
corresponding preset number for each patrol.
7. Delete a patrol.
You can move the cursor to CLEAR PATH and click IRIS+ to delete the current patrol.
8. Define the dwell time when running the fast patrol.
If you call the No.46 preset to enable the fast patrol, the speed dome will run the patrol
automatically according to the route consists of the configured preset 1 to preset 32. And you
can set the Patrol-D time switches from one preset to the other. 5 s, 10 s, 20 s, 30 s, and 60 s are
selectable.
HD-TVI Speed Dome User Manual
Figure 3-14 Edit the Patrol
错 误 未 找 到 引 用 源 。
! System-defined Presets to find the
25