HIKVISION HiLook PTZ-T5225I-A User Manual page 18

The speed dome shows the viewing direction when you manually control it to rotate.
Display N
Indication North Northeast
The north direction refers to the angle zero.
 Heat Parameter Configuration
You can set the HEAT CONTROL to TEMP (controlled by the temperature), ON or OFF.
 Fan Parameter Configuration
You can set the FAN CONTROL to TEMP (controlled by the temperature), ON or OFF.
 EIS (Electronic Image Stabilization) Configuration
You can set the EIS FUNCTION to ON or OFF.
 Preset Focus
You can set the preset focus function ON/OFF on PRESET FOCUS submenu.
 Protocol and RS-485 settings
 Select the protocol.
Choose the protocol on PROTOCAL submenu. You can configure it as AUTO MATCH, PELCO-P,
PELCO-D, or HIKVISION. When you choose AUTO MATCH, it is protocol self-adaptive.
 Set the protocol status.
Set the PROTOCOL STATUS to ON to enable the user-defined protocol.
 Enable the RS-485 configuration diagnosis.
You can set 485 CHECK to ON or AUTO for automatic RS-485 configuration diagnosis. If the
configuration is incorrect, an alert will be received; if you set the value as AUTO, it will
automatically stop the diagnosis when no errors exist.
HD-TVI Speed Dome User Manual
DISPLAY SETTINGS
ZOOM SHOW
P T SHOW
TIME SHOW
PRESET SHOW
ZONE SHOW
ADDRESS SHOW
ERROR RATE SHOW
BACK
Figure 3-6 Display Settings
Table 1-1 Viewing Direction Display
NE E SE
East Southeast
OFF
OFF
OFF
OFF
OFF
OFF
OFF
EXIT
S SW
South Southwest
12
W NW
West Northwest