JRC JLR-7900 Quick Reference page 58

Main menu
Sub-menu1
Sub-menu2
Sub-menu3
5> SENSOR
GPS MODE
FIX MODE
ELV MASK
HDOP
SMOOTHING
POSITION
SPEED
COURSE
RAIM ACCURACY
INITIALIZATION
LATITUDE
LONGITUDE
HEIGHT
DATE
TIME
SEND
BEACON
STATION SELECT
FREQUENCY
BIT RATE
SBAS
SBAS SEARCH
TYPE 0 INFO
RANGING
8> BEACON
DISPLAY
4-28
Setting the GPS Sensor
Select the GPS mode
【AUTO, GPS alone, Beacon, SBAS】
Select the fix mode
【AUTO,2D,3D】
Select the elevation mask
【5～89 degrees】
Selecting the HDOP
・Positioning is only performed if HDOP is lower than
the set value
【4,10,20】
Smoothing can be applied to measured positions,
speeds, and courses.
・The higher the smoothing value, the smoother the
results will be, but the greater time lag. Conversely, if
the smoothing value is set low, a great number of
changes will occur, but there will be little time lag
Smoothing can be set for position 【0～99sec】
Smoothing can be set for speed
Smoothing can be set for course 【0～99sec】
Set the RAIM accuracy level
【100,50,30,10,OFF】
Initializing the GPS sensor
Set the initial position (Latitude)
Set the initial position (Longitude)
Set the anntena height
Set the date
・Enter the current date in UTC
Set the time
・Enter the current time in UTC
Perforing the initilization
Setting the DGPS positioning for beacon
Set the beacon station selection method
【AUTO,MANUAL】
Set the frequency when station selection is set to
manual
Set the bit rate when station selection is set to manual
Setting the SBAS positioning
Select the SBAS satellite selection method
【AUTO,SBAS satellite number selecable】
Set whether type 0 information (test broadcast) data is
used
【ON(USE),OFF(Not USE)】
Set whether SBAS satellite is used for positioning in
the same way as the GPS satellite.
【ON(USE),OFF(Not USE)】
Displaying the beacon information
【ON,OFF】
Explanation
【0～99sec】
Default
AUTO
AUTO
5 deg
4
-
10 秒
10 秒
10 秒
100m
－
－
－
－
－
－
－
－
AUTO
－
－
－
AUTO
OFF
OFF
ON