Rtp - Planet Networking & Communication ICA-E8550 User Manual

Group Description
For example, system description and system name.
Provides general information from the physical interfaces.
Interface
For example, interface speed and MAC address.
Provides information about the mapping between network addresses and
Address
physical addresses for each physical interface.
Translation
For example, the IP/MAC addresses are to connect to the managed device.
Provides the status and operation of Network Layer (Layer 3).
IP
For example, the information and traffic flow of received/delivered package.
Provides the status and statistics of ICMP.
ICMP
For example, amount of receive/error message of ICMP.
Provides the status and operation of Transport Layer (Layer 4) using TCP
TCP protocol.
For example, TCP Local Port and incoming/outgoing TCP segments.
Provides the status and operation of Transport Layer (Layer 4) using UDP
UDP protocol.
For example, UDP Local Port and in/out datagram.
SNMP Provides the related statistics through SNMP

3.8.6 RTP

The RTP section allows user to configure RTP Settings.
If the RTSP Authentication is "Enabled", then the RTP streaming will require account name
and password authentication.
If the RTP B2 Frame is "Enabled", then the B2 frame is added to every video frame,
containing an additional information, such as motion detection status on each frame,
digital input and digital output levels, passive infrared status, other video intelligence
data, frame counter, frame-rate mode and the frame-rate, bitrate, resolution,
timestamp and much more. The user side can operate with video data easily, including
event management, storage consumption estimation, image resizing for preview, etc.
5 Mega-pixel Outdoor IR PoE Fisheye IP Camera
61
ICA-E8550