Event List - Planet Networking & Communication ICA-E8550 User Manual

5 Mega-pixel Outdoor IR PoE Fisheye IP Camera
ICA-E8550
the URL commands may be able to be stringed together, and multiple commands may be
issued in a single line.
An example would be when the access control device at the entrance detects an entry, this
device provides a DI signal to the PTZ camera, and triggers an event. This event then sends
a loopback command to the PTZ Camera itself (by setting its own IP as the HTTP CGI
server). The PTZ Camera then moves to a preset location, stays until the event is over, and
then moves back to another location. At the same time it moves to the pre-set location, it
increases the bitrate from 1M to 3M, and the frame rate from 4 fps to 8 fps. The bitrate / fps
changes are reverted at the end of event.

3.11.3 Event List

You may define a maximum of 10 Event rules, which will be shown in the abbreviated form in
the Event List panel. It will display under each Event ID, the days of the week it will be active,
the start time and duration of the active period, the type of the source of trigger, and the
actions used in the response. If the row is grayed out, this means the rule is currently not
enabled and stays inactive.
You may start creating a new event by clicking the event ID number in the list, for example
"2".
There are several parts to the Event rule:
When is it active?
You may choose to enable the rule or not. The settings will be kept in internal memory even if
the event rule is disabled. Select the days in a weekly cycle in which this rule and schedule is
active.
107