Table of Contents
Advertisement
Administrator Information
Items for Email Notification
Items
Reset Ink Level
Ink low
Maintenance box: end of service life
Maintenance box: nearing end
Administrator password changed
Paper out
Printing stopped*
Printer error
Scanner error
Fax error
Wi-Fi failure
Built-in SD card failure
PDL board failure
Related Information
"Configuring Email Notification" on page 442
&
Backing Up the Settings
You can export the setting value set from Web Config to the file. You can use it for backing up the contacts, setting
values, replacing the printer, etc.
The exported file cannot be edited because it is exported as a binary file.
Export the settings
Export the setting for the printer.
1. Access Web Config, and then select the Device Management tab > Export and Import Setting Value >
Export.
2. Select the settings that you want to export.
Select the settings you want to export. If you select the parent category, subcategories are also selected.
However, subcategories that cause errors by duplicating within the same network (such as IP addresses and so
on) cannot be selected.
>
>
Managing the Printer
Notice when the ink is expended.
Notice when the ink is nearing expended.
Notice when the maintenance box is full.
Notice when the maintenance box is nearing full.
Notice when administrator password has been changed.
Notice when the paper-out error has occurred in the specified paper source..
Notice when an error occurs, such as paper jam, paper cassette unset, or
mismatch of paper size or type.
Notice when the printer error has occurred.
Notice when the scanner error has occurred.
Notice when the fax error has occurred.
Notice when the error of the wireless LAN interface has occurred.
Notice when the error of the built-in SD card has occurred.
Notice when the error of the PDL substrate has occurred.
443
Backing Up the Settings
Settings and Explanation
Advertisement
Table of Contents
