Preparing To Scan - Epson EcoTank Pro ET-16680 Series User Manual

Administrator Information
1. Access Web Config and select the Network tab > LDAP Server > Connection Test.
2. Select Start.
The connection test is started. After the test, the check report is displayed.
Related Information
"Running Web Config on a Web Browser" on page 315
&
LDAP Server Connection Test References
Messages
Connection test was successful.
Connection test failed.
Check the settings.
Connection test failed.
Check the date and time on your
product or server.
Authentication failed.
Check the settings.
Cannot access the printer until
processing is complete.

Preparing to Scan

Scanning using the control panel
The scan to network folder function and the scan to mail function using the printer's control panel, as well as the
transfer of scan results to mail, folders, etc. are performed by executing a job from the computer.
>
Settings to Use the Printer
This message appears when the connection with the server is successful.
This message appears for the following reasons:
❏ The LDAP server address or the port number is incorrect.
❏ A timeout has occurred.
❏ Do Not Use is selected as the Use LDAP Server.
❏ If Kerberos Authentication is selected as the Authentication Method,
settings such as Realm (Domain), KDC Address and Port Number (Kerberos)
are incorrect.
This message appears when the connection fails because the time settings for the
printer and the LDAP server are mismatched.
This message appears for the following reasons:
❏ User Name and/or Password is incorrect.
❏ If Kerberos Authentication is selected as the Authentication Method, the
time/date may not be configured.
This message appears when the printer is busy.
406
>
Preparing to Scan
Explanation