Connecting Projector; Terminals Of Projector - Christie 38-RS1001-02 User Manual

CONNECTING PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from
computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just
by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.
REPLACEMENT OF TERMINAL
1 Remove 2 Screws on terminal.
2 Pull out terminal by holding handle.
3 Replace terminal. Insert terminal along Guide to fit Plug
into Socket.
4 Tighten screws to secure terminal.

TERMINALS OF PROJECTOR

INPUT/OUTPUT
TERMINALS
3 TERMINAL SLOTS (Factory set)
AUDIO
CONTROL PORT
ANALOG RGB
R L
(MONO)
AUDIO
R/Pr G/Y B/Pb H/HV V
R L
(MONO)
AUDIO
S-VIDEO
VIDEO/Y C
R
L
(MONO)
AUDIO OUT
SERIAL PORT IN SERIAL PORT OUT
R L
R/C JACK
RESET (MONO)
Plug
Figure shows HDB 15-PIN terminal (Optional parts).
HDB 15-PIN Terminal
CONTROL PORT
5 BNC Terminal
AV Terminal
USB
Screws
Guide
Socket
11