Yamaha F80BETL Service Manual page 88

POWR
3. Install the retaining plate 3, Woodruff
key 4, drive sprocket 5, and nut 6, and
then tighten the nut.
E
NOTE:
• Apply engine oil to the drive sprocket nut
before installation.
• Tighten the drive sprocket nut finger tight.
4. Check that the hole c on the retaining
plate is aligned with the projection d on
the cylinder block.
5. Install the timing belt and timing belt ten-
sioner.
NOTE:
For timing belt installation procedure, see
"Replacing the timing belt."
5-19
Power unit
S60C5240
d
c
S6D85300
6. Tighten the drive sprocket nut 6 to the
specified torque.
7
8
NOTE:
Use a deep socket 7 for this procedure.
Crankshaft holder 20 8:
90890-06552
Drive sprocket nut 6:
265 N·m (26.5 kgf·m, 195.5 ft·lb)
6
S6D85410
6D93G11