Setting Up Your Range - Dacor Discovery DYRP48DS Use And Care Manual

Cooktop Assembly
WARNING
To avoid the chance of fire, explosion or carbon monoxide
poisoning, do not attempt to use your range without the burners
completely and properly assembled. The burner rings spread the
flame evenly around the burner cap. The burner rings must be
properly seated for proper burner lighting and operation.
SimmerSear Burner Assembly
1. Put the burner heads in place as shown below. The
locating tab on the burner head goes in the keyed
hole as shown.
2. Put the burner rings on the burner heads. Match the
tabs on the bottom of the ring to the slots on the
burner head. Twist each ring back and forth slightly to
make sure it is properly seated.
3. Put the burner caps on top of the burner rings. You
may use either the supplied brass or porcelain caps.
The ridge around the bottom edge of the cap goes
around the top of the burner ring.
Step 
Step 
Tabs
Slots
Step

Put locating tab
into keyed hole
Keyed hole

Setting Up Your Range

Ridge on bottom of
burner cap
Burner ring
Burner head
Burner base
Standard Burner Assembly
4. Put the burner rings on the burner bases as shown
below. The bottom of the burner ring fits inside the
top of the burner base.
5. Turn the ring until it drops into place. Twist each ring
back and forth slightly to make sure it is properly
seated.
6. Put either the brass or porcelain burner caps on top of
the burner rings. The ridge around the bottom edge of
the cap goes around the top of the burner ring.
Step 
Step

SimmerSear
burners
Burner Locations
8
Ridge on bottom of
burner cap
Step 
Burner ring
Burner base
Standard
burners