Dacor Discovery DYRP48DS Use And Care Manual page 49

6. Touch Right or Left Oven Menu to select the oven to
be cleaned.
7. Touch Self Clean on the main menu.
8. Touch START · CONTINUE on the
control panel (to the right of the touch
display).
The control panel automatically locks the oven door
during self-cleaning. The latch prevents the door from
being opened since the high interior oven tempera-
tures can easily cause injury. If the door is not shut,
an error message will appear on the display. To cor-
rect the problem, touch CANCEL RIGHT or CANCEL
LEFT and wait approximately one minute, then close
the door. When the door is properly closed, start the
Self Clean process again.
The display shows the Self Clean cycle status:
◊ Cleaning indicates that Self Clean is in process.
◊ Door is Locked indicates that the door is latched.
◊ Cooling indicates that the oven is in the "cooling
down" portion of the Self Clean process.
Care and Cleaning
Door is Locked
If you want to stop the Self Clean cycle, touch CANCEL
RIGHT or CANCEL LEFT. Keep in mind that the oven
door will remain locked until it is safe enough to open.
Door is Locked will disappear from the display when the
door lock is released. You will still need to exercise caution
when the door lock is released because the inside of the
oven may still be hot.
After the Self Clean cycle is complete...
• The door latch will release when the inside has cooled
down. Cooling and Door is Locked will disappear
from the display. Exercise caution because the oven
will still be hot at the time the door lock is released.
• Reinstall the convection filter and oven racks before
using the oven.
• You may notice a powder ash residue in the bottom of
the oven after self-cleaning. This condition is normal.
Use a damp cloth or sponge to wipe up the residue
after the oven cools down.
Self-cleaning Tips
• If any soil remains in the oven after the Self Clean
cycle is done, you may repeat the cycle if you want.
• Self Clean the oven regularly to prevent excessive soil
build-up. Doing so will make the Self Clean cycle work
better and reduce smoke and odors.
GreenClean Cleaning System
The GreenClean cleaning feature is a quick,
simple, steam clean process used to clean light
soil inside the ovens. Green Clean allows you to
save time and energy over the Self Clean pro-
cess, which should be used for heavier soil build up. Also,
unlike the Self Clean process, the Green Clean process
may be performed on both ovens at the same time.
• To avoid steam burns, do not pour water into an oven when
it is hot.
• The water remaining inside the oven will still be hot to the
touch when the door is opened after the process is complete.
1. Remove all utensils from the oven.
2. Making sure the oven is cool, pour 1 1/2 cups of water
(preferably distilled) into the recessed portion of the
oven floor. For slightly heavier build up, you may mix
a teaspoon of hand dishwashing soap into the water
prior to pouring.
47
WARNING
continued...