Table of Contents
Advertisement
DIN Rail Mounting option
This Series is ideal if you need high precision signal conditioning. Sometimes, it is not
necessary to have front panel indication, so in such cases, we offer a DIN rail mounting option,
which allows the meter to be installed within a control panel.
Detachable connectors add to the simplicity of installation, and of course the setup method is
identical to the panel mounting version, so you don't need to learn a new method.
The display remains active, so you can see at a glance the status of your signals, and
programming is simple, using the 4 buttons.
Output functions include isolated 16 bit 4-20mA, 0-10V, -10 to +10V, RS232, RS485 and up
to 4 alarms with a wide choice of alarm functions.
Install the meters in a suitable protective electrical control enclosure according to local wiring
regulations. See specifications for maximum allowable temperature in enclosure. Allow
adequate air circulation.
Securing into the panel
Use standard top-Hat DIN rail 35 mm x 7.5 mm (EN 50022, BS 5584, DIN 46277-3)
Ventilation
There should be sufficient ventilation in the enclosure to ensure that the meter's case is
always kept to less than 60C.
Meter Spacing.
Meters should be spaced apart sufficiently to allow a free flow of ventilation air around the
meters, such that no part of the case will exceed 60C
8
Advertisement
Table of Contents
