Table of Contents
Advertisement
After you have calibrated your meter, you can use the SCALE feature to make fine adjust-
ments to calibration, without affecting the calibration itself.
Examples
1.Changing weight units of measure from kg to pounds
You could also use the SCALE to convert your readout from kg to pounds, without affecting
the calibration. Simply set SCALE = 2.205 and your meter which was calibrated in kg will
now read in pounds.
2. Correcting for gravitational variance
Your weighing system was calibrated where gravitational acceleration = 9.812m/s
don) You then move the system to Bankok where gravitational acceleration is reduced to
9.782m/s
2
You can correct for this difference by setting Scale = 9.812 / 9.782 = 1.003, so that a given
mass in Bangkok will show the same weight as it did in London. Set Offset = 0.0000
See
http://en.wikipedia.org/wiki/Earth%27s_gravity
!! This feature is available in Advanced Mode only !!
Set1
Digit
1
Press 3 seconds
Set1
Digit
2
Set1
Digit
3
Set1
Digit
4
You may want to adjust an offset value also, see separate OFFSET page for this feature.
Set2
Output
Alarms
OK
Max/Min
Reset
Set2
Output
Alarms
OK
Max/Min
Reset
Set2
Output
Alarms
OK
Max/Min
Reset
Set2
Output
Alarms
OK
Max/Min
Reset
Press to accept
Scale Factor adjustment
Lockout Switch must be OFF
Press repeatedly until you see
SCALE
, followed by the existing scale
factor.
(Default =
Use DIGIT button to select each digit
in turn, UP or DOWN buttons to
increase or decrease each digit's
value. Press OK when done.
2
(Lon-
OFF
Circuit board
ON
)
001.000
Done!
33
Advertisement
Table of Contents
