Table of Contents
Advertisement
Linearisation with Theoretical Cal. - cont'd.
Set1
Digit
Max/Min
5
Set1
Digit
Max/Min
6
Display
rd 08
rd 07
rd 06
rd 05
rd 04
rd 03
rd 02
rd 01
rd 00
In00
Set2
Output
Alarms
OK
Reset
Set2
Output
Alarms
OK
Reset
In01
The display will show
an editing screen. Here you can enter your
next calibration input signal level using
DIGIT button to select each digit in turn.
Increase or decrease the value of each
digit using the UP or DOWN buttons.
Press OK when set.
The display will now show
You can now tell the meter what it should
display for this input signal.
Select each digit in turn with the DIGIT
button, and increase or decrease each
digit's value using the UP or DOWN
button, until the display is set as required.
Press OK when done.
The display will show
Press OK if you want to Add another
calibration point, you will repeat the previ-
ous steps, each time incrementing
and
rd XX
up to In 09 and rd 09 which are
the last available points.
If you want to finish adding points, press
Set2 until the display shows
then confirm by pressing OK
If you want to abort the setup, press Set2
until the display shows
press OK
In02
In03
In04
In 01
followed by
rd 01
Add.Pt
In XX
SAVE
, and
qUIt
and then
Done!
In05
In06
In07
Input
In08
25
Advertisement
Table of Contents
